Table of Contents
Advertisement
How to insert batteries: Use a screwdriver to unscrew the back cover of
the remote. Install two AAA 1.5V alkaline type batteries according to the
diagram (batteries not included). Fix the battery cover with a screw.
How to remove batteries: Use a screwdriver to unscrew the back cover
of the remote. Open the cover and remove the two AAA 1.5V alkaline type
batteries. Close the battery cover, fix with a screw.
WARNING
• Do not charge non-rechargeable batteries for the remote.
• Batteries for the remote must be inserted with the correct polarity.
• When the remote is low in battery, please remove and swap the batteries
• Rechargeable batteries for the remote must be charged under adult su-
pervision.
• Rechargeable batteries must be removed from the remote before being
charged.
CHARGING PROCEDURES
• For safety purposes, charging must be done by adults.
• When initially assembled, connect the (red) battery wires under the
hood. Charge for 8-12 hours before using.
• The charging port is located on the dashboard. Follow the instructions to
charge the battery.
• If the car is starting to slow down, this indicates the battery is low. Re-
charge for 8-12 hours, maximum 20 hours. Do not overcharge or under-
charge.
• First, insert the charger into the charging port.
• Carefully insert the charger outlet into the power outlet. Please note the
car will not turn on when the car is connected.
11
Advertisement
Table of Contents
