Operation - Flash FLM-600 User Manual

User Manual •Instrukcja Obsługi

5. OPERATION

1. Connect the power lead to the power
socket with earth line. The machine will start
heating.
2. You have to wait same time (about 10
minutes) until the machine has sufficiently
warmed up. Press the „A" or „B" key on the
remote controller. The machine will spray fog
and the LEDs will light in different colours.
Press it as long as you need. For safety
reasons, the pump will only work when the
machine is hot enough.
3. Can set the machine at a high place (with
bracket) or on the ground. Do not spray fog to
people directly and the lean angle should less
than 15°C.
4. Often check whether there is enough fag
liquid in the tank. The unit might be seriously
damaged if it operates without fog liquid.
5. lf the fag is small, plum has noise or there
has a no fog, please power off and check fog
It is forbidden to use smoke
liquids with improper
parameters, we recommended
to use only FLASH-BUTRYM
smoke liquids.
liquid, fuse, the connector of remote console
and power plug. lf the problem could not be
solved after check these parts, please stop
check and send it back to distributor for
repair. Repair: Please clean the fog machine
to avoid the damage of spare parts and
decrease the repair charge. Don't let the fag
machine become dirty. Close the cap of liquid
can after add fag liquid.
After about 40 hours continually use, please
use 80% distilled water and 20% vinegar to
clean the dirty in refractory pipe.
Disassemble the spray mouth and use
vinegar to clean it to keep expedite before
heat. Reequip the spray mouth after cool
and add fag liquid for next use. Others: Clean
regularly to extend the lifetime of machine.
Use dry cloths to clean machine and keep
dry while stare. Unplug the machine from
the mains prior to cleaning, refilling the tank,
changing the fuse, repairing or doing any
other maintenance.
Smoke Liquids
Scan the QR code