Operation - Flash FLM-1200 User Manual

5. OPERATION

1. Connect the power lead to the power
socket with earth line. The machine will
start heating.
2. You have to wait same time (about 10
minutes) until the machine has sufficiently
warmed up. Press the „A" or „B" key on the
remote controller. The machine will spray
fog and the LEDs will light in different
colours. Press it as long as you need. For
safety reasons, the pump will only work
when the machine is hot enough.
3. Can set the machine at a high place (with
bracket) or on the ground. Do not spray fog
to people directly and the lean angle should
less than 15°C.
4. Often check whether there is enough
fag liquid in the tank. The unit might be
seriously damaged if it operates without
fog liquid.
5. lf the fag is small, plum has noise or there
has a no fog, please power off and check
FOG MACHINE FLM-1200 + LED 3in1 PILOT RE • Art No F5100308
fog liquid, fuse, the connector of remote
console and power plug. lf the problem
could not be solved after check these parts,
please stop check and send it back to
distributor for repair. Repair: Please clean
the fog machine to avoid the damage of
spare parts and decrease the repair charge.
Don't let the fag machine become dirty.
Close the cap of liquid can after add fag
liquid.
After about 40 hours continually use, please
use 80% distilled water and 20% vinegar to
clean the dirty in refractory pipe.
Disassemble the spray mouth and use
vinegar to clean it to keep expedite before
heat. Reequip the spray mouth after cool
and add fag liquid for next use. Others:
Clean regularly to extend the lifetime of
machine. Use dry cloths to clean machine
and keep dry while stare. Unplug the
machine from the mains prior to cleaning,
refilling the tank, changing the fuse,
repairing or doing any other maintenance.