Operation - Flash FLM-600 User Manual

User Manual • Instrukcja Obsługi
4.1 Voltage specification
Input Voltage
230V

5. OPERATION

1. Connect the power lead to the power
socket with earth line. fle machine will
start heating.
2. You have to wait same time (about 10
minutes) until the machine has sufficiently
warmed up. Press the „A" or „B" key on the
remote controller. fle machine will spray
fog and the LEDs will light in different
colours. Press it as long as you need. For
safety reasons, the pump will only work
when the machine is hot enough.
3. Can set the machine at a high place (with
bracket) or on the ground. Do not spray fog
to people directly and the lean angle should
less than 15°C.
4. Often check whether there is enough
fag liquid in the tank. fle unit might be
seriously damaged if it operates without
fog liquid.
5. lf the fag is small, plum has noise or there
has a no fog, please power off and check fog
liquid, fuse, the connector of remote console
Total Power
430W
and power plug. lf the problem could not
be solved after check these parts, please
stop check and send it back to distributor
for repair. Repair: Please clean the fog
machine to avoid the damage of spare parts
and decrease the repair charge. Don't let the
fag machine become dirty. Close the cap of
liquid can after add fag liquid.
After about 40 hours continually use, please
use 80% distilled water and 20% vinegar to
clean the dirty in refractory pipe.
Disassemble the spray mouth and use
vinegar to clean it to keep expedite before
heat. Reequip the spray mouth after cool
and add fag liquid for next use. Others:
Clean regularly to extend the lifetime of
machine. Use dry cloths to clean machine
and keep dry while stare. Unplug the
machine from the mains prior to cleaning,
refilling the tank, changing the fuse,
repairing or doing any other maintenance.
Frequency
50/60Hz