Intermec EasyCoder 301 Supplementary Manual page 2

Approved Antenna List - Liste d'antennes approuvées
Intermec P/N Supplier P/N
N/P Intermec Fournisseur
- Mobile Mark BP6-915LCP
- Mobile Mark DLM3-915RS
- Mobile Mark EDN#241
1-206589-00 Intermec 1-206589-00
1-971040-001 Intermec 1-971040-001
805-609-001 Cushcraft SP9028PC156RSM
805-610-001 Maxrad MP8906
805-622-002 Kathrein 25-178
805-623-002 Kathrein 25-277
805-626-001 Kathrein 25-578
805-629-001 Mobile Mark PN10-915RCPI
805-642-001 Tyco M/A-com MAA-000153-AT000
805-654-001 Huber Suhner 84024995
805-654-002 Huber Suhner 84024996
805-655-001 Huber Suhner 84024999
805-655-002 Huber Suhner 84024999
805-816-002 Cushcraft S9026XR1RRN
ITA915017 Intermec ITA915017
For Users Outside of the United States or Canada
Caution: This marking indicates that the user should read all included documentation before use.
This Intermec product transmits and receives data using either an 865 MHz or an 869 MHz RFID system.
Programming and configuration information for the transceivers is also provided in the host device documentation. Please check the
Intermec web site for additional documentation at www.intermec.com.
This supplement includes lists of countries that have accepted, restricted, or prohibited the use of this product:
• For 865 MHz, see the "Country List for 865 MHz Compliance" on page 8.
• For 869 MHz, see the "Country List for 869 MHz Compliance" on page 9.
865 MHz Compliance Information
Hereby, Intermec Technologies Corporation declares that the 865 MHz RFID Module is in compliance with the essential requirements and
other relevant provisions of R&TTE Directive (1999/5/EC). This product has been assessed to the following standards:
• ETSI EN 302 208
• ETSI EN 301 489
• EN 60950
Warning: CENELEC regulations limit exposure to radio frequency (RF) radiation. To comply with these regulations,
operators of this device must maintain a distance of at least 20 cm (8 in) from the antenna assembly. While the device is
on, the operator's body and parts of the body such as eyes, hands, or head, must be 20 cm (8 in) or farther from the cover
of the antenna assembly.
Warning: CENELEC regulations also require that the antenna assembly of this device be installed in accordance with the
installation procedures to allow the operator to comply with the limit. Use of antennas and accessories not authorized
may void the compliance of this product and may result in RF exposures beyond the limits established for this
equipment.
The transmitter module's maximum output power is 2 W. The products using this module are intended for business and industrial
environments. They should not be used in residential environments and by children.
This product is marked with this logo and uses radio frequency bands that are not harmonized throughout the
0981
European Community.
2
Description
Description
Patch CP - Plaque PC
Patch LP - Plaque PL
Patch LP - Plaque PL
Patch LP - Plaque PL
Patch LP - Plaque PL
Patch CP - Plaque PC
Patch LP - Plaque PL
Patch CP - Plaque PC
Patch CP - Plaque PC
Patch LP - Plaque PL
Patch CP - Plaque PC
Patch LCP - Panneau PCG
Panel RCP - Panneau PCD
Panel LCP - Panneau PCG
Panel RCP - Panneau PCD
Panel LCP - Panneau PCG
Patch CP - Plaque PC
Patch LP - Plaque PL
Gain (dBi) Cable Loss (dB)
Gain (dBi) Perte du câble (dB)
2.5 2.4
3.0 2.4
3.0 2.4
-3.4 N/A
-34 N/A
4.0 N/A
8.0 2.4
6.5 2.4
5.5 2.4
6.0 2.4
7.0 2.4
7 2.4
5.5 2.4
5.5 2.4
7 2.4
7 2.4
3.0 2.4
-5.7 N/A