Advertisement
1
①
①
安装固定座：
1. 用钻头在墙上钻2个直径6mm的固定座安装孔，孔深35mm。
2. 在固定座安装孔内分别打入膨胀管，然后用自攻螺钉分别将上
固定座和下固定座定位在墙上。
3. 调整上固定座和下固定座的位置，使其相距1031mm，竖直对
齐，锁紧自攻螺钉，将上、下固定座紧固在墙上。
Install the fixing ring：
1. Drill two Ф6mm holes in the wall. The depth of holes should be
35mm.
2. Insert the wall plugs into the hole then locate the fixing ringI
and the fixing ringII onto the wall with the tapping screws.
3. Adjust the distance between the fixing rings to be1031mm.
Tighten them on the wall. fixing ring on the wall.
2-Φ6mm
孔深 Depth:35mm
②
②
2
紧定螺钉
Fixing Screw
组装管组件：
取支臂组件，确认支臂组件接头上有O型密封圈，依图所示摆正好
支臂组件与下直管位置，将支臂组件的接头朝下插入下直管内，用
内六角扳手将下直管顶部的紧定螺钉拧紧，确保不渗漏。
注：组装后，支臂组件和切换阀的方向需在同一位置。
Assemble the both tubes:
Take the arm module. Make sure the connector of arm module
has the o-ring. Put the arm module into the top of straight tube
as the drawing. Screw down the fixing screw of straight tube
using the inner hexangular spanner.
Note:
The direction of the arm module and the diverter valve
should be same.
3
Advertisement
