HOMCOM 820-299V90 Instruction Manual page 3

Operating Instructions
Never cover the heater or obstruct the opening at the base of the heater, this
could cause overheating and consequent risk of fire.
Never move the heater when it is operating, this could cause the bulb breakdown.
Please turn the heater off if you want to move it.
When you turn the heater on for the first time you may notice a slight odor, this is
harmless and will stop after a short amount of time.
Heater Control Panel
The following switches are located at back of the heater.
2
Insert plug into mains socket
Select the desired functions:
Switch 2 (O/I ): Switchs on/off electricity supply to the heater and flame effect
●
● Note: This switch must be in the ON (I) position for heater to operate with or without
heat
● Switch 3 ( I ): Switchs on/off 1000W heat output
● Switch 4 ( II ): Switchs on/off 2000W heat output with switch 3.
● Note: The flame effect can be operated with or without heat.
Rotate thermostat knob (1) clockwise or anti-clockwise to increase or decrease
desired room temperature setting.
Safety Cut-Off
This appliance is fitted with a safety cut-off which will operate if the heater overheats
(e.g. Due to blocked air vents). For safety reasons, the heater will NOT automatically
reset.
To reset the appliance, disconnect the appliance from the mains supply for at least 15
minutes. Reconnect the supply to the mains and switch on the appliance.
3 4
3
1