Page 1
OWNER’S MANUAL ™ Gourmet Series Marine Gas Grill Model A10-918-2 IMPORTANT, read these instructions carefully before use. Familiarize yourself with the appliance before connecting it to its gas container. Keep these instructions for future reference.
IMPORTANT SAFETY WARNINGS READ ALL INSTRUCTIONS BEFORE OPERATING. Each Magma Gas Grill is individually fire tested before it leaves the factory. ® For this reason, the burner on your grill may be slightly discolored. INSTALLATION INSTRUCTIONS CONTROL VALVE REGULATOR Valve will feel loose and will rotate easily. Even though the valve feels loose, it will not leak.
Page 3
MOUNT HARDWARE Fasteners are supplied for both Single Mount and Dual Mount grill mounting options. See Magma Catalog or Website for best mount selection. Single mount through-bolt applications Dual mount applications 4 Carriage bolts & lock nuts. 4 Carriage bolts & lock nuts. Only 4 bolts required for grill mounting.
OPERATE ONLY ON “LOW” WHEN LID IS CLOSED. ALWAYS OPERATE WITH GREASE TRAY IN PLACE. WARNING: Do not overheat grill. Magma Grills do not require pre-heating. Stainless Steel loses anti-corrosive characteristics when subjected to extreme heat. Most grilling is done on low temperature with the lid closed.
ELECTRODE SPARK ADJUSTMENT CAUTION: Spark can cause small shock. Do not leave fingers on or near electrode wire while engaging igniter. approximately 1/8” from gas . Carefully adjust wire if required. DISASSEMBLY & RE-ASSEMBLY right slot (see C). To remove liner from outer shell you must disconnect the electrode wire remove electrode from liner.
Control Valve - All valves are set and tested at our factory. Do not attempt to adjust or disassemble the valve in any way. Call Magma if you suspect it is not adjusted properly. Clean valve with a cloth and remove any debris obstructing the orifice.
FROM A NON-REGULATED TANK DIRECTLY TO GRILL. Magma's grills are designed for use with small disposable propane canisters or with pre-regulated low-pressure propane and optional low-pressure valves. Running high-pressure propane fuel supply lines on a boat is in violation of American Boat & Yacht Council (ABYC) guidelines and is not considered a safe application.
Page 8
CONTENTS A) (1) 3/16” Hex key wrench for lid removel. B) Pack of (4) 1/4”-20 x 5/8” hex head screws and internal lock washers for Single Mount non-through-bolt applications, including Style 1 “LeveLock”. C) Pack of (4) 1/4”-20 x 5/8” carriage bolts and lock nuts for dual mount and single mount applications.
Need help?
Do you have a question about the A10-918-2 and is the answer not in the manual?
Questions and answers