Table of Contents
Advertisement
Quick Links
Gas Grill Models: A10-1218-2, A10-1218-2-CSA
For questions regarding performance, assembly,
operation, parts, or returns, contact the experts
at MAGMA by calling (562) 627-0500
For questions regarding performance,
assembly, operation, parts, or returns,
contact the experts at MAGMA directly
7:00 a.m. - 4:00 p.m. Pacific Time Monday thru
1 - 800 - 86 - MAGMA
Friday or e-mail us at mail@MagmaProducts.com
IMPORTANT, read these instructions carefully before use. Familiarize yourself with the appliance
before connecting it to its gas container. Keep these instructions for future reference.
OWNER'S MANUAL
GOURMET SERIES GAS GRILL
by calling TOLL FREE
7:00 a.m. - 5:00 p.m.
Pacific Time Monday thru Friday
or e-mail us at
magmamail@aol.com
™
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Magma A10-1218-2
Summary of Contents for Magma A10-1218-2
- Page 1 MAGMA directly 7:00 a.m. - 4:00 p.m. Pacific Time Monday thru by calling TOLL FREE 1 - 800 - 86 - MAGMA Friday or e-mail us at mail@MagmaProducts.com 7:00 a.m. - 5:00 p.m. Pacific Time Monday thru Friday or e-mail us at magmamail@aol.com...
-
Page 2: Important Safety Warnings
• USE PROPANE GAS ONLY. FUEL STORAGE SHOULD BE IN COMPLIANCE WITH THE AMERICAN BOAT AND YACHT COUNCIL (ABYC) STANDARDS A-1 (9), MARINE LIQUIFIED PETROLEUM GAS (LPG) SYSTEMS. • FOR NATURAL GAS APPLICATION CONTACT MAGMA. • ALWAYS LIGHT GRILL WITH LID OPEN. -
Page 3: Installation Instructions
The valve was designed to be loose fitting in order to allow safe, easy installation and removal of the propane canister and so it easily swings without resistance to fit all applications. MOUNT HARDWARE See Magma website for replacement part numbers Fasteners are supplied for both Single and valve applications. MagmaProducts.com Mount and Dual Mount grill mounting options. -
Page 4: Operating Procedures
OPERATE ONLY ON “LOW” WHEN LID IS CLOSED. ALWAYS OPERATE WITH GREASE TRAY IN PLACE. WARNING: Do not overheat grill. Magma Grills do not require pre-heating. Stainless Steel loses anti- corrosive characteristics when subjected to extreme heat. Most grilling is done on low temperature with the lid closed. -
Page 5: Disassembly And Reassembly
ELECTRODE SPARK ADJUSTMENT CAUTION: Spark can cause small shock. Do not leave fingers on or near electrode wire while engaging igniter. • Electrode wire should be approximately 1/8” from gas exit hole in burner. Carefully adjust wire if required. DISASSEMBLY & RE-ASSEMBLY •... -
Page 6: Maintenance
Control Valve - All valves are set and tested at our factory. Do not attempt to adjust or disassemble the valve in any way. Call Magma if you suspect it is not adjusted properly. Clean valve with a cloth and remove any debris obstructing the orifice. -
Page 7: Troubleshooting Guide
• Magma on-board CNG (natural gas) valves allow Magma grills to be installed to an existing on-board, pre-regulated low pressure CNG (natural gas) system. • Use only Magma Type 4 Low Pressure CNG (natural gas) control valves. Visit our website at MagmaProducts.com to view valve application guide. See your local dealer for proper hose and fittings. -
Page 8: Limited Warranty
Discoloration or Corrosion caused by exposure to excessive heat or failure to properly clean and care for the stainless steel surfaces. If the product fails to operate due to a defect in materials or workmanship during the warranty period, the defective part will be repaired or replaced at Magma’ s option. If you wish to obtain performance under this limited warranty, you should contact Magma’... - Page 9 ADDENDUM FOR GAS GRILL MODELS A10-1218-2AU-3, A10-1218-2GSAU-3 SOLD IN AUSTRALIA CAUTION: Accessible parts may be very hot. Keep young children away. ONLY USE IN WELL-VENTILATED AREAS. • CARBON MONOXIDE HAZARD-THIS APPLIANCE CAN PRODUCE CARBON MONOXIDE WHICH HAS NO ODOUR. DO NOT USE IN ENCLOSED AREAS, (FOR EXAMPLE: CAR, TENT, CARAVAN, MOBILE HOME) MAY CAUSE DEATH.
- Page 10 HOW TO ISOLATE GAS SUPPLY IN THE EVENT OF A LEAK (smell of gas): Cylinders: If there is a leak on your appliance (smell of gas), immediately attempt to turn off cylinder valve. Turn off appliance control valve. Remove appliance to a well-ventilated location away from any ignition source. STORAGE: NEVER LEAVE GAS CYLINDERS CONNECTED WHEN NOT IN USE! Cylinders: When you have finished using this appliance, turn gas cylinder off;...
Need help?
Do you have a question about the A10-1218-2 and is the answer not in the manual?
Questions and answers