Magma Newport Gourmet Series Owner's Manual

Marine gas barbeque

Advertisement

Quick Links

OWNER'S MANUAL
Gourmet Series Marine Gas Barbeque
Model A10-918
For questions regarding performance, assembly,
operation, parts, or returns, contact the experts
at MAGMA by calling TOLL FREE IN U.S.A. AND
CANADA 1-800-86-MAGMA
7:00 a.m. - 5:00 p.m. Pacific Time Monday thru
Friday or e-mail us at magmamail@aol.com
Read all instructions before operating. Save manual for future reference.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Newport Gourmet Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Magma Newport Gourmet Series

  • Page 1 Model A10-918 For questions regarding performance, assembly, operation, parts, or returns, contact the experts at MAGMA by calling TOLL FREE IN U.S.A. AND CANADA 1-800-86-MAGMA 7:00 a.m. - 5:00 p.m. Pacific Time Monday thru Friday or e-mail us at magmamail@aol.com...
  • Page 2: Important Safety Warnings

    • USE PROPANE GAS ONLY. FUEL STORAGE SHOULD BE IN COMPLIANCE WITH THE AMERICAN BOAT AND YACHT COUNCIL (ABYC) STANDARDS A-1 (9), MARINE LIQUIFIED PETROLEUM GAS (LPG) SYSTEMS. • FOR NATURAL GAS APPLICATION CONTACT MAGMA. • ALWAYS LIGHT BBQ WITH LID OPEN. • NEVER LEAVE HOT BARBECUE UNATTENDED.
  • Page 3 Fish Rod Holder application table leg applications ON-BOARD FUEL SYSTEMS APPLICATION •For on-board LPG Systems, use Magma A10-220 Low Pressure LPG Control Valve and A10-225 LPG Hose Kit. •For on-board CNG Systems, use Magma A10-230 CNG Control Valve. Lid Lock...
  • Page 4: Operating Procedures

    OPERATE ONLY ON “LOW” WHEN LID IS CLOSED. ALWAYS OPERATE WITH GREASE TRAY IN PLACE. WARNING: Do not overheat barbecue. Magma BBQ’ s do not require pre-heating. Stainless Steel loses anti-corrosive characteristics when subjected to extreme heat. Most grilling is done on low temperature with the lid closed. If medium or high heat is required, grill with lid open.
  • Page 5: Disassembly And Reassembly

    ELECTRODE SPARK ADJUSTMENT CAUTION: Spark can cause small shock. Do not leave fingers on or near electrode wire while engaging igniter. • Electrode wire should be approximately 1/8” from gas exit hole in burner. Carefully adjust wire if required. DISASSEMBLY & RE-ASSEMBLY •...
  • Page 6: Maintenance

    All valves are set and tested at our factory. Do not attempt to adjust or disassemble the valve in any way. Call Magma if you suspect it is not adjusted properly. Clean valve with a cloth and remove any debris obstructing the gas outlet orifice using a pin or needle.
  • Page 7: Troubleshooting Guide

    (see page 5) Igniter/electrode wire loose or Reconnect wire between disconnected igniter & electrode (see page 5) Wire is shorted causing spark Call Magma from wire before electrode No spark being generated Call Magma Burner will not No gas flow...
  • Page 8: Limited Warranty

    Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. Neither Magma dealers, nor the retail establishment selling this product has any authority to make any warranties or to promise remedies in addition to or inconsistent with those stated above.

This manual is also suitable for:

Newport a10-918

Table of Contents