Advertisement
Headgear Adjustment
RATCHET
KNOB
Head Size Adjustment: Headband tightness is adjusted by pushing in the ratchet knob and
turning to adjust to desired comfort level. This knob is located at the back of the helmet. HEAD
GEAR CROWN ADJUSTMENT is made by adjusting crown strap for vertical placement on the
head and snapping the pin into the hole to lock securely in place.
Tilt: View angle is adjusted on both the left and right sides of helmet. Adjustment is made by
loosening outside tension knobs of headgear and releasing tilt lever from its current location and
moving it to another location. It is recommended this adjustment be completed one side at a
time. Retighten tension knobs when finished. The view angle adjustment needs to be set the
same for both tilt levers.
Fore/Aft Adjustment: Fore/Aft adjustment is the distance between the userʼs face and lens. To
adjust, loosen the outside tension knobs to allow for headgear to be repositioned to a different
location. This should be done one side at a time and both sides should be located the same for
proper auto-darkening filter operation.
CARTRIDGE OPERATION/FEATURES
Variable Shade Control
The shade can be adjusted from shade 9 to 13 based upon welding process or application (refer to
Shade selection chart on page 4). The variable shade control knob is mounted to shell for external
adjustment.
Solar Power
This helmet is powered by solar energy. As such, there is no battery that requires replacement.
OPERATING INSTRUCTIONS
CROWN
ADJUSTMENT
HEADGEAR
FORE/AFT
ADJUSTMENT
TILT ADJUSTMENT
TILT
LEVER
3
SHELL
Advertisement
