Table of Contents
Advertisement
en Troubleshooting
Fault
The laundry is too
damp.
Fan noise during the
washing phase.
The programme dura-
tion changes during
the wash cycle.
Drum jerks after the
programme starts.
Rushing, hissing
noise.
Detergent or fabric
softener drips off the
seal and collects on
the door or in the seal
fold.
Start / Pause cannot
be operated.
44
Cause and troubleshooting
The water pressure is low.
No remedial action possible.
Laundry is not spun sufficiently.
Always select the highest possible spin speed for
▶
the washing programme in question.
Thick and multi-layered fabrics require a longer drying
time.
Set a timed programme for the subsequent drying.
▶
→ "Programmes", Page 24
Process fan is active.
Not a fault – normal operating noise.
▶
The programme operation is optimised electronically.
This may change the programme duration.
Not a fault – no action required.
▶
The unbalanced load detection system eliminates an
imbalance by repeatedly redistributing the laundry.
Not a fault – no action required.
▶
Note: When loading, where possible, place large and
small items of laundry together in the drum. Different
sized items of laundry distribute themselves better
during the spin cycle.
Foam detection system switches on a rinse cycle if
foam build-up is too high.
Not a fault – no action required.
▶
This is caused by an internal motor test.
Not a fault – no action required.
▶
Water is flushed under pressure into the detergent
drawer.
Not a fault – normal operating noise.
▶
Too much detergent/fabric softener in the detergent
drawer.
When dosing liquid detergent and fabric softener,
▶
observe the marking in the detergent drawer and
do not dose above this.
Drying phase active.
Not a fault – no action required.
▶
Advertisement
Table of Contents
