Table of Contents
Advertisement
en Troubleshooting
Fault
lights up.
flashes.
"E:95" lights up altern-
ately with End.
All other error codes.
The appliance is not
working.
The programme does
not start.
38
Cause and troubleshooting
Water level measurement system is defective.
Call the after-sales service.
▶
→ "Customer Service", Page 46
The temperature is too high.
Wait until the temperature has dropped.
▶
→ "Cancelling the programme", Page 30
▶
Water level is too high.
Select a suitable programme for draining.
▶
→ "Programmes", Page 24
Door is not closed.
Close the door.
1.
Press Start / Pause to start the programme.
2.
Laundry is caught in the door.
Open the door again.
1.
Remove any trapped laundry.
2.
Close the door.
3.
Press Start / Pause to start the programme.
4.
Detergent dosage is too high.
Immediate measure: Mix one tablespoon of fabric
▶
softener with 0.5 litres of water and pour the mix-
ture into the left-hand compartment (not for outdoor
clothing, sportswear or items stuffed with down).
Reduce the amount of detergent for the next wash-
▶
ing cycle with the same load.
The water pressure is low.
See
▶
→ "
", Page 38
Malfunction
Call the after-sales service.
▶
→ "Customer Service", Page 46
The mains plug of the power cord is not plugged in.
Connect the appliance to the power supply.
▶
The circuit breaker in the fuse box has tripped.
Check the circuit breaker in the fuse box.
▶
There has been a power cut.
Check whether the lighting in your kitchen or other
▶
appliances are working.
You have not pressed Start / Pause.
Press Start / Pause.
▶
Advertisement
Table of Contents
