Table of Contents
Advertisement
Fault
Water is leaking out at
the water outlet hose.
Fluff on the laundry.
Water inlet noise dur-
ing the drying phase.
Drying programme
does not start.
The laundry is too
damp.
Cause and troubleshooting
Water outlet hose is not connected correctly.
Connect the water outlet hose correctly.
▶
→ "Water outlet connection types", Page 14
Fluff has accumulated in the drum.
Run the Drum Clean
▶
laundry or detergent.
Drying phase requires water.
Not a fault.
1.
Make sure that the water tap also remains open
2.
during the drying phase.
Door is not closed.
Close the door.
1.
Press Start / Pause to start the programme.
2.
No drying programme is selected.
Select a suitable drying programme.
▶
→ "Programmes", Page 24
Unsuitable programme for the type of fabric.
There has been a power cut.
Check whether the lighting in your kitchen or other
▶
appliances are working.
The load is too large.
After the end of the programme, warm laundry feels
damper than it actually is.
Remove the laundry from the drum as soon as the
1.
drying programme has finished.
Spread the items of laundry for cooling.
2.
Unsuitable dryness level set.
Drying target not adjusted.
Load too small.
Moisture sensor dirty.
Water tap is closed during the drying phase.
Make sure that the water tap also remains open
▶
during the drying phase.
The ambient temperature is greater than 30 °C.
Ensure that the ambient temperature is lower than
▶
30 °C.
Insufficient air circulation at the appliance's installation
location.
Ventilate the appliance's installation location.
▶
Troubleshooting en
programme without any
43
Advertisement
Table of Contents
