In short:
To turn the heat pump on / off:
If the symbol
•
displayed, the heat pump is switched off.
Press and hold the rotary button on the room unit for about 7s. The heat pump is
•
switched on, the display shows the room temperature.
When the heat pump is switched on, pressing and holding the rotary button (7s)
•
switches the heat pump off.
To set the room temperature:
Press the rotary button.
•
The desired indoor temperature flashes on the display.
•
Turn the button to the right to increase the desired room temperature by 0.5 °C, turn
•
the button to the left to decrease it.
Press the rotary button again and the display will display the room temperature
•
again.
For more information, see chapter 3.1.5 on page 15.
•
To determine the outdoor temperature:
Turn the button to the right and the outdoor temperature will be displayed for 5s.
•
To determine the temperature of service water (TUV):
Turn the button to the left and the water temperature (if fitted) will be displayed for
•
5s.
HEAT PUMP
AIR / WATER
WITH REGULATION
ACOND® THERM
OPERATING MANUAL
Software version 140.1 and 140.2
is on the display and the room temperature is not
Need help?
Do you have a question about the PRO-N and is the answer not in the manual?
Questions and answers