Advertisement
CODE THE multiGuard® remote WITH FEATURES FROM
HEAT PUMP REMOTE
1. Prepare the heat pump remote control with the desired func-
tions. For example: temperature 22 °C, auto swing, auto fan.
2. Send a text message from a mobile phone to the multiGuard®
remote.
Use the text: M1 Warm (makro no., + optional text —
remember the space between).
The message must be sent to the number of the SIM card that's
installed in the multiGuard® remote
3. When multiGuard® remote has received the SMS you get an
acknowledgement: ―OK>> M1 Warm‖. Macro M1 is now
called ―Warm‖ (after the optional text in paragraph 2).
4. A red LED at the multiGuard® remote now fl ashes rapidly for
30 sec. It tells that the unit is ready to receive a signal from the
remote control.
5. Point the heat pump remote control towards the top of
multiGuard® remote. Press the ―warm‖ button as if you are
activating the heat pump. The infrared signal is now recorded
and stored in the multiGuard® remote. It is activated by
sending a text message: Warm
6. Repeat the steps above to record other features e.g. at macro
no. M2, M3 etc. with other names.
7. Place the multiGuard® remote in sight of the infrared receiver of the heat pump. Let one
of the IR-transmitters pointing directly towards the heat pump.
OPERATE THE HEAT PUMP AT LONG DISTANCE
1. Send a text message with the name of the macro for example Warm
multiGuard® remote will now send the signal that starts the heat pump with the setting:
temperatureat 22 °C, auto swing, and auto fan.
2. You will receive an acknowledgement as a text message with the text ―OK>> R1‖
R1 refers to M1 (macro number 1), R2 for macro 2, etc.
Advertisement
