Profort multiGuard Quick Start Manual

KEEP TRACK OF THE HEAT WITH multiGuard® remote
With multiGuard® remote you can control your heat pump even when you're far away from the
house.
The device also alerts when the temperature drops or it can turn on the water heater. See more
about other features on the back.
To enable the use of multiGuard® remote you must mount the device with SIM card and power
as well as transferring information from the heat pump remote control.
MOUNT THE multiGuard® remote SIM-card
SIM card
Use a standard SIM card from an optional telephone operator. The phone number of the card must
be used when you need to send a text message or call the device.
1. Check the SIM card. Put the SIM card into an ordinary mobile phone. Check that you can
call and send text messages to and from your phone.
2. Disable PIN request. While the SIM card is in your phone, disable the PIN (if necessary see
the manual for your mobile phone).
3. Install the SIM card. Insert the SIM card into multiGuard® remote.
Power
1. Connect the power cord: Turn on the power
2. The red LED lights up for about 30 seconds and flashes
slowly.
3. Install the backup battery
4. The unit is ready
Take your mobile phone and send a text
message to multiGuard® remote
multiGuard® remote sends an infrared signal to
the heat pump. The pump reacts as if you stood
next to it.
It will now be nice and warm when you return to the
house
.
multiGuard® remote
.