Kenmore SpotLite KW2001 Use & Care Manual page 12

WARNING
Always unplug power cord from
electrical outlet before performing any
service on carpet cleaner.
Empty the dirty water tank when the dirty
liquid reaches the "Max Fill" line and there
is a loss in suction. During normal use,
debris may accumulate in the dirty water
tank. In order to keep the carpet cleaner
functioning properly, rinse out the dirty
water tank with clean water after each
use.
1. Lift up the dirty water tank from the side
of the unit.
2. Pull the dirty water tank cover release
horizontally, and open the cover.
Dirty Water Tank
Cover Release
EMPTYING THE DIRTY WATER TANK
Dirty
Water
Tank
3. Empty the tank. Drain liquids into a
suitable receptacle or drain. Rinse the
tank thoroughly with clean water. Allow
the tank to air dry before reinstalling.
DO NOT wash in the dishwasher.
DO NOT install damp.
4. Close the tank cover. Push back the
cover release to original place to secure
the cover.
5. Before replacing tank back into the unit,
remove any debris from the air outlet
area as shown.
6. Replace the dirty water tank back into
the unit, pressing down firmly until it
feels secure.
- 12 -
Air Outlet