The unit is equipped with an InGaAs/InP detector that is responsive in the wavelength range of 900 - 1700 nm. The TIA-3000 is provided with an FC fiber optic receptacle. Other fiber optic connectors can be provided on request. The output signal is presented to a type K SMA female connector.
50 ohm load at the oscilloscope or other measuring device to be used. The active area of the TIA-3000 is 50 microns in diameter. Standard coupling fiber is 9µm. Special orders with 50µm coupling fiber for use with multimode systems are available.
Typical frequency Response Curve The bandwidth of the TIA-3000 is from 30 KHz to typically 10 GHz (-3 dB ). Refer to the following Bode plot. Spectral Response The approximate relative response curves of the detectors employed is as shown below. Note that...
Page 6
TIA-3000 Specifications Detector Type InGaAs/InP (900nm-1700nm) Current Responsivity 0.8 A/W @ 1550nm Typical Transimpedance 400 Min. 50 Typ. Maximum Linear Input Power 1.25mW Maximum Input Power w/o Damage 6.25mW Peak, 2.5mW Avg. Bandwith@1550nm Typ. 10 GHz typ. (8 GHz min.)
Page 7
FROM DEFECTS IN MATERIALS AND MANUFACTURING. THE FOREGOING WARRANTY IS THE ONLY WARRANTY, EXPRESS OR IMPLIED, GIVEN BY TTI, I.E., THERE IS NO WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE. TTI HEREBY DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTY OTHER THAN THE WARRANTY IN THE FIRST SENTENCE TO THE FULLEST EXTENT PERMITTED BY LAW.THE SOLE AND...