Table of Contents
Advertisement
24
www.aeg.com
Water supply
Capacity
1) Refer to the rating plate for other values.
2) Cold water connection is recommended for best washing performance.
14. INSTALLATION
24 mm
There should be a minimum
2mm gap between the top of
the dishwasher and
underside of bench top
Install the appliance under a kitchen
counter.
Put the appliance adjacent to a water tap
and a water drain.
Cold water
Place settings
Tools and equipment needed
8 mm
Secure dishwasher with
brackets or screws provided
DISHWASHER
Gap on both sides should be
equal, & no greater than
5 mm per side.
If floor is not level, adjust
levelling legs to suit
2)
A
3,5x16 mm
D
2x
The hose should not be
extended by more than
2 metres or water pump-
out problems may occur
600mm max
300mm min
For the venting of the appliance only
water hoses and mains cable openings
are necessary.
Dimensions of the appliance and the
cavity:
min 5 °C
14
Installation kit
2x
4x
B
4x30 mm
E
1x
Remove entire plastic
membrane from sink trap
spigot & fit drain hose to spigot
with clamp
SINK
POWER OUTLET
Min. 400 mm straight
section
4x
C
F
1x
400mm
min
Advertisement
Table of Contents
