Table of Contents
Advertisement
10
www.aeg.com
How to set the programme
selection mode
The appliance is in programme selection
mode when the display shows the
programme number P1.
After activation, the appliance is in
programme selection mode by default. If
not, set the programme selection mode
the following way:
Press and hold simultaneously
in programme selection mode.
How to enter user mode
Make sure the appliance is in
programme selection mode.
To enter user mode, press and hold
simultaneously
the indicators
flash and the display is blank.
6.2 The rinse aid empty
notification
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
When rinse aid chamber is empty, the
rinse aid indicator is turned on notifying
to refill rinse aid. If the drying results are
satisfactory while using multi-tablets only,
it is possible to deactivate the notification
for refilling rinse aid. However, for best
drying performance, always use rinse
aid.
If standard detergent or multi-tablets
without rinse aid are used, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse
aid empty notification
Make sure the appliance is in user mode.
1. Press
• The indicators
and
until the appliance is
and
,
,
.
are off.
• The indicator
• The display shows the current
setting.
2. Press
3. Press the on/off button to confirm the
setting.
6.3 The rinse aid level
It is possible to set the released quantity
of rinse aid between level 1 (minimum
quantity) and level 6 (maximum quantity).
Level 0 deactivates the rinse aid
dispenser and no rinse aid is released.
Factory setting: level 4.
until
How to set the rinse aid level
and
Make sure the appliance is in user mode.
1. Press
• The indicators
off.
• The indicator
flashes.
• The display shows the current
setting: e.g.
2. Press
change the setting.
3. Press the on/off button to confirm the
setting.
6.4 Acoustic signals
Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic signal
is deactivated but it is possible to
,
and
activate it.
still flashes.
–
= the rinse aid empty
notification is deactivated.
–
= the rinse aid empty
notification is activated.
to change the setting.
.
,
= level 4.
– The levels of rinse aid are
from 0A to 6A
where level 0A means rinse
aid is not used.
repeatedly to
and
are
still
Advertisement
Table of Contents
