Intex CS20110 Owner's Manual page 27

1. Start up the unit:
Plug the power cord into the electrical outlet and test the GFCI/RCD (circuit
breaker). Switch on the unit.
With the Filter Pump turned "ON" and operating, the green "Pump" light on the
control panel will be on and code "00" appears on the electronic control
station's LED, indicating that the unit is in a Stand-By Mode. This is normal.
2. Unlock keypad controls:
Press and hold the
press and hold the button for another 2
"beep". The LED flashes "00". This procedure unlocks the keypad control
buttons.
3. Set operating hours for Saltwater System:
Increase the scheduled number of operating hours by pressing the button
reduce them by pressing the button
required operating hours related to each pool size. Press the button
the desired hours. You can press
built-in timer will now activate your Saltwater System, at the same time each day,
for the number of hours you have set.
NOTE: The Saltwater System will not operate if the filter pump is not operating.
4. Lock keypad controls:
Wit h the desired hour value showing, press and hold the
until you hear a long "beep". Then press and hold
you hear the second long "beep". The green "WORKING" indicator on the control
panel will light up within a few seconds to indicate that the saltwater system has
started sanitizer production. Locking the control buttons into this setting prevents
unauthorized changing of the operating cycle.
NOTE: If you forget to lock the keypad controls, the system will
automatically lock it and start working 1 minute later.
5. Readjust operating time if necessary:
The operating hours can be re-adjusted if necessary. Just repeat the steps 2
through 4.
6. Test the copper concentration in the
pool water.
The Saltwater System recommends a copper level of 0.2 to 0.3 ppm. This is
easily tested by the copper ion test strips provided. If the test result is
0.2~0.3 ppm, go directly to step 8.
SAVE THESE INSTRUCTIONS
SALTWATER SYSTEM OPERATION
button for 2 seconds until you hear a short "beep". Then
seconds until you hear the second short
. See the "Operating Time Table" for the
if you have selected too many hours. The
(1 to 12 hours max per cycle)
for another 2 seconds until
, or
to select
button for 2 seconds
Page 21