Table of Contents
Advertisement
Connecting to your home
network automatically
If your router has a WPS function, you
can connect the appliance to your home
network automatically.
If your router does not have a WPS
function, you will need to connect the
appliance to your home network
manually .
Wi-Fi must be switched on on the
appliance.
Switch the appliance on.
1.
Press and hold the Remote start }
2.
button for more than 3 seconds.
'ž£ (connect automatically) will
appear on the display panel.
Press the Start button to connect. †
3.
will flash on the display panel.
The appliance will now try to connect
to your home network.
Activate the WPS function on your
4.
home network router within the next
2 minutes.
If the appliance has connected to your
home network successfully, ™©Ÿ
(connected) will appear on the display
panel and † will be lit continuously.
You can exit the Home Connect
5.
settings by pressing the
Remote start } button.
If a connection could not be
Note:
established, "§§ (fault) will appear on
the display panel. Check whether your
appliance is in range of your home
network.Try connecting automatically
again or connect your appliance
manually ~ Page 50.
Home Connect
en
49
Advertisement
Table of Contents
