Table of Contents
Advertisement
O3Arc Operating Manual
Attaching tubing
The ozone generator has female Luer Lock connectors for the Oxygen In,
Ozone Out, and Aux Out ports. These are designed to be used with tubing
that has a male Luer lock on one side. Attach the male Luer Lock with tubing
attached to the female Luer Lock and turn clockwise. This will lock the tubing
in place. To disconnect the tubing, turn the male Luer Lock counter-clockwise.
If you are ozonating water or oil:
Promolife provides an ozone check valve with each ozone generator. The
ozone check valve should always be used when water or oil is being used, as
it can help prevent backfl ow issues. Using the ozone generator with water or
oil and without the ozone check valve will void the warranty. On new units the
check valve comes already attached to your silicone tubing.
ATTACHES TO OZONE
GENERATOR
Turning on your oxygen source
It is important to turn your oxygen source on before the ozone generator. For
tanks, turn on the fl ow for at least 15-30 seconds. For an oxygen concentrator,
run the concentrator for fi ve minutes before turning on your ozone generator.
Concentrators take several minutes to reach maximum purity levels.
Note: When powering the O3Arc Plus for the fi rst time you will sometimes
notice a delayed start. This is because the O3Arc plus has an internal solenoid
valve that is magnetically operated that needs to be charged before operating.
The solenoid valve allows the ozone gas to change directions with a push of
the button. This is a normal occurrence and can be expected from time to
time.
Promolife, Inc.
AIR FLOW
888-742-3404
CHECK
VALVE
www.promolife.com
AIR FLOW
TO PERIPHERAL
6
Advertisement
Table of Contents
