Table of Contents
Advertisement
O3Arc Operating Manual
Quick start guide for most accurate ozone output
For detailed instructions, see the next page.
1. Set your oxygen source to 1/4 LPM. Set O3Arc Power to P-10. Run for two
minutes to prepare generator for use or testing. For why we recommend this,
see the back of this manual.
2. After two minutes, you may adjust the oxygen and Power settings to reach
your chosen concentration.
3. When session is complete, turn off the ozone generator.
4. Wait 15-30 seconds to purge ozone from the lines, then turn off the oxygen.
5. If the ozone generator is hooked up to a bubbler, make sure the generator
is higher than the bubbler and the check valve is installed.
Safety
Please read the following safety guidelines throughly before attempting to use
your equipment.
As with all electric devices, this equipment should never be allowed to come
in contact with water.
Only qualifi ed personnel should be allowed to set up, maintain, and operate
this equipment.
The equipment must be operated using a properly grounded electrical
circuit that is protected by either a fuse or circuit breaker.
Promolife, Inc. assumed no liability for damages or injuries incurred by
misuse of this product.
There are two versions of this ozone generator.
O3Arc Standard - This is a digital ozone generator with a built-in display that
allows the user to digitally control the ozone output and set a countdown
timer that will turn off ozone production after a chosen time. [Figure B]
O3Arc Plus - This digital ozone generator functions the same as the Standard,
with the addition of an AUX port for secondary ozone access and a destruct
port. The AUX port can be operated by the AUX power button or a foot switch.
[Figure C]
Promolife, Inc.
888-742-3404
www.promolife.com
4
Advertisement
Table of Contents
