Table of Contents
Advertisement
O3Arc Operating Manual
Turning off your oxygen source
After you are done using the O3Arc, turn the ozone generator off fi rst. Wait at
least 15 to 30 seconds and then turn off your oxygen source. This will allow the
ozone cell and tubing to fl ush out any remaining ozone, which will increase
the lifespan of all the parts.
Unhook all tubing from the ozone generator when not in use.
Ozone Gamma Chart
An ozone gamma chart is included in your package. Please refer to this chart
to set your concentration.
To set your ozone output, choose the gamma (ug/ml) concentration you desire.
Set your oxygen regulator to the matching LPM in the left hand column. Then
set the Power setting on your O3Arc to the matching Power Mode number in
the top column.
Additional Information
Operating conditions: The ozone generator is designed to run with either an
oxygen concentrator or an oxygen tank. Using a pure oxygen source eliminates any
contaminates from being produced that may enter or harm the ozone generator. If
using a tank, only use a regulator limited to 50 PSI or you risk damaging the ozone cell.
Using an oxygen tank regulator that exceeds 50 PSI will void the warranty.
Operating Environment: Please choose the best operating environment that is
available at the chosen site. Setup in an area that is free of airborne moisture and
particles. Make sure the ozone generator is kept clean and dry. Dust particles and
condensation pose a challenge to the consistent operation of all ozone generators. For
consistent ozone concentrations, please operate at room temperature.
Pressure Relief System: The O3Arc comes equipped with a pressure relief system. If
high pressure occurs inside the ozone generator, only oxygen will be released. This one
of a kind system protects your ozone generator.
Check Valve: Each ozone generator comes with one ozone check valve. These will
last anywhere from 3 to 6 months depending on use. This device is designed to
catch liquid from entering the ozone generator. We recommend replacing every 3 to
6 months. Troubleshooting your check valve: Simply remove the tubing from your
Promolife, Inc.
888-742-3404
www.promolife.com
10
Advertisement
Table of Contents
