Intermatic IG2TM Installation Instructions

SURGE PROTECTION
Telephone Indoor Stand Alone Protection
Models
Model Numbers:
IG2TM
IG4TM
Optional Modules
IG2T
Parts List
Description
Mounting Frame
Cover / Back plate
IG2T (in Model IG2TM)
IG2T (2nd module in Model IG4TM)
Screws-self threading (3/8" Torx T20 / slot head)
Ground Wire
3/4" x 6 Pan Head Screws (
3/4" anchors (
not shown
Additional Parts
Flush Mount Kit
Description
Flush Mount Cover Plate
Mounting Bracket
Screws-self threading (3/8" Torx T20 / slot head)
Screws-self threading (5/8" Torx T20 / slot head)
3/4" x 6 Pan Head Screws (
Tools Required
Flat head screw driver, Torx head
screw driver, Awl or hole punch, drill,
1/8" and 3/16" bits.
Notes:
1. Telephone protection is compatible with
Voice and Fax lines, Modem lines and
DSL (Digital Subscriber Lines.)
2. Coaxial protection is compatible with
Local antenna, Cable/Satellite and
Cable Internet lines.
Before Installing
1. Check the parts in both packages against the Parts Lists shown above. Contact Intermatic if parts are missing.
2. It is suggested that you read these instructions completely before installing the Stand Alone Protection (SAP) unit.
Note: These modules rely on a good ground connection to function properly. Ground availability
Flush Installation
)
not shown
)
Quantity
)
not shown
L
should be a consideration when selecting an installation location.
Do not install Protection Devices during Electrical Storms.
I
NSTALLATION
Description:
2-line telephone protector with indoor enclosure (NEMA 1)
4-line telephone protector with indoor enclosure (NEMA 1)
2-phone line protection module
Quantity Reference
1 A
1 B
1 C
1 D
2 E
1 F
4
4
E
Reference
1 H
1 J
4 K (Fig.4)
2 L
4
I
NSTRUCTIONS
C
B
Figure 1
A
H
Figure 2
F
A
D
B
E
J