Front Wheel Installation - Delta rDrive User Manual

FRONT WHEEL INSTALLATION

Bicycle wheels are designed to be removeable for easier transportation and for
repairing punctures. Insert the hub axle on the wheel into the fork dropouts. The
wheels are secured with the supplied axle nuts and washers (where applicable) which
are threaded onto the hub axle.
1. Ensure all the packing material is removed from the fork paying close attention
to the plastic fork protector at the bottom of the fork legs. Note: you may need to
loosen the axle nuts a few turns to get the axle into the fork dropouts.
2. Check that the axle is fully inserted into the fork dropouts and tighten the axle nuts
to 30Nm torque.
3. The wheel should spin freely.
4. At this point it is recommended you check the inflation of both the front and rear
tires. Please refer to the Tires, Tubes and Wheels maintenance section.
HEX NUT
DROP OUT
FRONT VIEW OF FRONT WHEEL
Page 10
FRONT WHEEL HUB
DROP OUT
HEX NUT
AXLE