Assist Functions; Troubleshooting - Delta mDrive User Manual

ASSIST FUNCTIONS

The display has 2 different assist functions:
• Assist levels (1-5), with the Up/Down buttons.
• "Walk Assist" press and hold to activate.
• Light is toggled on and off by holding down the "Light" button.
• Walk assist is selected by holding down the "Down" button.
Walk-assist allows you to drive up to 4 mph without the use of the pedals and
regardless of the assist level setting. This function is, for example, used on hills and
other rough paths. It is especially helpful when pushing the bike up steep slopes.

TROUBLESHOOTING

If the first LED in the battery indicator starts to flash, this indicates that the system has
detected an error. The numbers of flashes determine the error code.
Number of
flashes
3
4
7
8
9
If there is no power to the LED display check the battery is correctly charged and
correctly installed to the bike. If there is still no power then please contact your retailer
or reach out to us at 800-474-6615 or www.designbydelta.com for Delta Customer
Service.
Page 18
Indicates
Controller error
Display error
Speed sensor error
Low voltage error
High voltage error
Solution
Contact your retailer.
Contact your retailer.
Contact your retailer
Recharge the battery.
Contact your retailer.