Two-channel full-range or subwoofer system (APX2180)
In this application, the APX2180 is used to drive two speakers.
Subwoofers in stereo
•
Set crossover mode switch to LP
•
Set crossover frequency to ~80Hz
•
Fine-tune as required
•
2 Ω
Full-range speakers or components in stereo
•
Set crossover mode switch to OFF
Component speakers in stereo with separate subwoofer amp
•
Set crossover mode switch to HP
•
Set crossover frequency to ~200Hz for 4-inch speakers
Subwoofers and component speakers at the same time
•
Set crossover mode switch to OFF
•
Install passive crossovers on subwoofers (inductor) and components (capacitor)
16
~100Hz for 5.25-inch speakers
~75Hz for 6.5-inch speakers
~65Hz for 6 x 9-inch speakers
Subwoofers
Full-range co-axial
or
Component speakers
APX/DPX Amplifiers