Do you have a question about the PD253D and is the answer not in the manual?
Questions and answers
Richard P. Newman
June 26, 2025
After successful daily use for more than 18 months we noticed mold in the removable tank. We took the tank out and emptied it we attempted to pop the top off to clean it out to disinfect it but unable to pop the top off. Concerned it would crack. Is there an easy way to accomplish this? Thanks.
Page 1
Home Dehumidifier Please read the manual carefully before using the unit PD253D USER MANUAL www.kesnos.com...
Page 2
TO ACCESS CUSTOMER SUPPORT FASTER If there is any problem of the product, please contact Kesnos Customer Service at support@kesnos.com with your Purchase Order ID to help you...
Page 3
BEFORE FIRST USE: To prevent any internal damage, it is very important to keep the unit (like this one) upright throughout its journey. Please leave it standing as the picture shown below and outside the box for 24 HOURS before plugging it in.
TABLE OF CONTENTS Safety Instructions..............Parts Description ..............Control Interface..............Operation Instructions............Cleaning & Maintenance............Troubleshooting..............Special Notes............... Technical Parameters.............. Warranty & Contact Us............Statement The graphics and functions provided in this manual may not be the same as the actual product. Please always refer to the actual product. The model of the machine on the manual is for reference only, please check the corresponding content and operate the machine based on the actual product.
SAFETY INSTRUCTIONS Safety Notes: For your safety, please read the manual carefully and keep the manual for future reference. Please use this product according to the instructions of installation and operation of this manual. ● Before cleaning the dehumidifier, turn off the power and unplug it from the power outlet.
1.Control Panel Display Area Child Lock Lighting Button Press the button and hold for 2 Control the LED panel's light seconds, the control panel will on/off. be locked. Timer Button Speed Button Press to initiate the auto-start Control the fan speec. or auto-stop feature.
OPERATION INSTRUCTIONS 2.Setting Setting Humidity The humidity level can be set within a range of 30%RH to 80%RH in 5% increments. When it starts to work, it will first automatically detect and show the room's ● humidity. In dehumidification mode (other modes are invalid), press the "DEHUMIDIFY" button, you can change the humidity selection.
Page 9
OPERATION INSTRUCTIONS Speed Button Control the fan speed. Press to select either High or Normal fan speed. Higher fan speed will result in quicker moisture removal. Set the speed high for maximum moisture removal. When the humidity has been reduced and quiet operation is more preferred, set the fan speed back to Normal.
Page 10
OPERATION INSTRUCTIONS Auto Defrost Feature When the dehumidifier is running at a lower temperature, the system will automatically determine whether there is a presence of frost. lf any frost exists, it will defrost automatically. Defrost Action The fan runs at high wind speed when the compressor stops, and the LED screen displays the defrosting symbol.
Page 11
OPERATION INSTRUCTIONS 4.Instructions for Drying Clothes Step 1. Note: Keep away the unit from the water drips of the washed clothes. Step 2. It's the best would be more suitable...
Page 13
CLEANING AND MAINTENANCE 6. Empty The Water Tank Two ways are available to remove the collected water. Use the Water Tank Ways to Empty the Water Tank Pull the water tank out from the bottom with both of your hands. Put the water tank back in place, the water full indicator will go out.
Page 15
CLEANING AND MAINTENANCE 7.Continuous Drainage Remove the power supply, take out the water tank, open the drainage cap, insert the water hose into the continuous drain drainage port and put back the water tank. Connect the power supply to start the operation.The outlet of the water hose should be lower than the continuous drainage port by more than 3.9 inches, and can not be bent.(Note: The diameter of continuous drainage port is 0.63 inches.)
Page 16
CLEANING AND MAINTENANCE WARNING: A-Cleaning the dehumidifier body Please use a soft and a slightly wet textile or cloth to clean it. B-Cleaning filter Pull out the filter. Clean the filter: Use a vacuum cleaner to gently remove the dust from the surface of the filter.
If all troubleshooting steps have been exhausted and the issue is still occurring, please feel free to reach out to Kesnos Customer Service to get further assistance.
Page 18
This is to prevent the frequent start of the machine. Does the machine stop working just now? The dehumidifier is designed to work in the humidity range of 30%-80%. Above or below this range, it will not work. Room temperature is too low, Please wait until the or below 41℉...
Page 19
If the dehumidifier is still not working properly as expected and the troubleshooting steps or solutions above may not resolve the issue. Please unplug the power and shut down the dehumidifier, then contact Kesnos Customer Service at support@kesnos.com.
SPECIAL NOTES Do not insert thin rods and hard objects into the machine body to avoid malfunction and danger. When cleaning the Please clean the filter every dehumidifier, please use the two weeks (do not use hot wet textile to wipe gently, do water above 104°F, alcohol, not shoot the water directly.
CONTACT US Warranty Kesnos offers a 12-month warranty to all of our products together with the original proof of purchase when a defect occured, including those newly purchased and unused, from Kesnos or through an authorized reseller, wholly or substantially, or as a result of faulty manufacturing parts, or workmanship during the Warranty Period.
Page 24
We are expecting to see our products fulfill your life and hear your voice. Your satisfaction means a lot to us. Please tag us if you share a snap on your social media. www.kesnos.com...
Need help?
Do you have a question about the PD253D and is the answer not in the manual?
Questions and answers
After successful daily use for more than 18 months we noticed mold in the removable tank. We took the tank out and emptied it we attempted to pop the top off to clean it out to disinfect it but unable to pop the top off. Concerned it would crack. Is there an easy way to accomplish this? Thanks.