Product Safety No�ce Don't Ride Un�l You Read This: This user manual will help you assemble and operate your new electric bike. Be sure to read all of the informa�on in this manual before riding. Always wear a helmet when riding your electric bike. NOTE TO ALL RIDERS UNDER 18 YEARS OF AGE: It's very important that you get Keep the two keys properly.
Abuse - We do not cover physical damage due to negligent care and extreme riding. Whenever you ride the Jasion Electric Bike, you risk severe injury or even death from loss of control, collisions, and falls. Use cau�on and ride at your own risk.
Product Overview Assembly LCD Display Visit www.jasionride.com for addi�onal help with assembly, including a step-by-step video walk-through. Display Controls Derailleur Grip Trigger Thro�le Front Light Switch Horn Switch USB Charging Port Saddle Ba�ery Tail Light Locate the quick release lever. Open the lever and Line up the fork with the axle at the center of remove the thumb nut and cone spring (opposite the the wheel.
Assembly Assembly For be�er pedaling, safety and overall riding comfort, posi�oning the seat at the right height is important. The rider's leg length is used to determine the seat's posi�on. When you pedal, your hips should remain level and your legs should be almost fully extended at the bo�om of the pedal stroke, but not over-extended. To determine the right seat height, sit on the eBike with one pedal at its lowest point andplace the ball of your foot on the pedal.
Page 7
Assembly Assembly Adjus�ng the Suspension Fork Adjus�ng the Seat Posi�on and Angle The suspension fork can move up and down up to 80mm to To change the angle and horizontal posi�on of the seat: cushion bumps in the riding surface, which can make riding (1) Use a 6 mm Allen wrench to loosen the seat on a rough road or trail smoother and more comfortable.
Hold the key and sliding the ba�ery through the drivetrain (the rear cog, chain tensioner, and around the front chainring) smoothly. off the mount. Note: If the pedal/ chain doesn't run smoothly or something seems misaligned, please contact Jasion Support.
Start-up procedure A�er the bike has been properly assembled according to the assembly video, all components are For your convenience, the jasion ba�ery can be removed. secured correctly, a cer�fied, reputable mechanic has checked the assembly, and you have read this en�re manual, turn on the bike and select a pedal assist level following the steps below:...
Charge Your E-Bike Charge Your E-Bike Before using the electric bike, you must fully charge the ba�ery. Charging Port The ba�ery can be removed from the bicycle for charging. To remove Charging the ba�ery, see the previous remove ba�ery sec�on for details, and Port then carefully pull the ba�ery up un�l the ba�ery detaches from the Tail Light...
LCD Display Controls Display and Se�ng Opera�on Direc�ons Error Display USB Turn on bike Press and hold un�l power engages (1) Display Backlight Power Level Press and hold un�l power off (1). If you ride for 5 minutes (the �me can Turn off...
Page 12
For more Mode, then press or to choose the set-up item. Then press M bu�on, when the se�ng detailed instruc�ons, please visit Jasion Help Center parameter flashes, press or bu�ons to adjust the parameter, press M to save,and press M bu�on twice again to quit the Se�ng Mode.
Page 13
Number Set up the item Specific The screen appears Magnet sensor se�ng Do not change Ba�ery voltage se�ng Do not change Press +/- boutons to set the gear range Thro�le se�ng Do not change Pedal assist se�ng 3/5/9/6. Press +/- bu�ons to adjust the speed limit Speed limit se�ng value.
Page 14
Recommended Service Intervals Daily Care and Maintenance Regular inspec�on and maintenance are the key to ensure bikes from jasion func�on as intended, Cleaning and Storage and to reduce wear and tear on their systems. Recommended service intervals are meant to be If you see stains on the bike body, wipe them off...
Page 15
Safety Check Pre-Ride Safety Checklist 8. Frame, Fork, and Check that the frame and fork are not bent or broken. No�ce: Before every ride, and a�er every 25-45 miles(40-72 km), we advise following the If either frame or fork are bent or broken, they should be replaced. Seat pre-ride safety checklist.
4. Repair or replace Even �res equipped with built-in, flat-preventa�ve �re liners, like those that come with bikes from jasion, can and do get flats from punctures, pinches, impact, and other causes. When �re wear becomes evident or a flat �re is discovered, �res and/or Reduced range 1.
: What if the e-bike arrived missing accessory or broken part? ITEM SPECIFICATIONS : Please take a photo and send to Jasion Support Team by sending email: Model support@Jasionride.com and Jasion Support Team will reply you soon and send correct...
To be eligible for a return, your item must be in the same condi�on that you received it, 6. If you return a product to Jasion, (a) without an RMA from Jasion(b) without all parts included in the original package, Jasion retains the right to refuse delivery of such return.