Page 1
S W E D E N UNDER-CABINET RANGE HOOD Models: RHC-3092 (30in) RHC-3692 (36in) RHC-4892 (48in) USER MANUAL Your satisfaction is guaranteed. If you are not completely satisfied with our Under-Cabinet Range Hood and the results it brings, we insist that you let us...
IMPORTANT SAFETY INSTRUCTIONS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, READ THE FOLLOWING: • Use this unit only in the manner intended by the manufacturer. • Make sure that the voltage indicated on the rating plate of the appliance corresponds to your outlet voltage.
Page 4
• Always turn the hood ON when cooking at high heat or when flambéing food. • Clean ventilation fans frequently. Grease should not be allowed to accumulate on the fan or filters. WARNING: TO REDUCE THE RISK OF INJURY, IN THE EVENT OF A COOKTOP GREASE FIRE, READ THE FOLLOWING: •...
INSTALLATION REQUIREMENTS PARTS SUPPLIED: Wall Anchor Screw Range Hood & Gasket RHC-3092 (30in) x 1 RHC-3692 (36in) x 1 RHC-3092 (30in) x 8 RHC-4892 (48in) x 1 RHC-3692 (36in) x 8 RHC-4892 (48in) x 8 Wall Mounting Power cord (attached...
LOCATION REQUIREMENTS: This range hood has been designed to be installed under-cabinet, above a stove/hob. Before start- ing the installation, consideration should be given as to how the installation will be carried out, ensuring adequate space and clearances above the stove/hob. When installed, the range hood must be positioned at least 24in (61cm) and at most 36in (91.4cm) above the cooktop.
FOR THE MOST EFFICIENT OPERATION: • Minimum mount height between cook top to hood bottom should be no less than 24’’ for electric cook tops or 30’’ for gas stove tops, and no higher than 30’’ for electric cook tops or 36’’...
This installation is for mounting the product under wall cabinetry. Ensure your wall has the proper support to hold the range hood weight (RHC-3092 30in - 48.4lbs / 22kg, RHC-3692 36in - 52.8lbs / 24kg, and RHC-4892 48in - 62.7lbs / 28.4kg). These instructions are general guidelines;...
• Fasten all connections with sheet metal screws and tape all joints with certified HVAC foil tape or duct tape. • Use caulking to seal exterior wall or roof opening around the cap. Horizontal Option 1: Option 2: Wall Venting Side wall cap Roof cap Vertical...
4. For installing under the cabinet with recessed bottom, it is recommended (but not necessary) to attach 4-inch wide wood filler strips (not provided) on each side. CAUTION: If moving the cooking range is necessary to install the hood, ensure the power of an electric range is turned OFF at the main electrical box.
Page 11
B - Attach the Range Hood to the Wall Via Wall Mounting Bracket B-1. Using references in Height & Clearance on Page 5, mark the leveling point of the hood. Using the 2 top holes of the Wall Mounting Bracket (Part G) as a guide, insert two Wall Anchor Screws (Part F) on the wall, leaving 1/8”space away from the wall.
Page 12
7. NOTE: This step applies ONLY to 48in models: Install the Filter Spacers between Baffle Filters as represented in the Baffle Filters Layout section below. Baffle RHC-3092 (30in) Filters Two baffle filters Layout: RHC-3692 (36in) Two baffle filters + 1 small in between...
RANGE HOOD USE RANGE HOOD CONTROLS: 00:00 Remote Clock/ Lights Digital Minus Plus Power Control Timer On/Off Display Touch Touch On/Off Sensor Button Button OPERATING THE RANGE HOOD: - To Turn the Fan ON press the Power Button and press the “+” button to increase the fan speed: •...
RANGE HOOD CARE WARNING: To reduce the risk of electrical shock, DO NOT clean the hood while it's operating. WARNING: Never put your hands into the area housing the fan when the fan is operating. CLEANING & MAINTENANCE: IMPORTANT: Clean the hood, grease tray, and baffle filters frequently according to the following instructions.
ATTENTION: Wear gloves to protect against sharp edges. 1. Unplug the range hood, or turn off the breaker. 2. Use a soft tool to gently dislodge the bulb's rim from its position OR remove baffle filters and push the bulb out from the inside of the unit. 3.
Weight: RHC-3092 30in - 48.4lbs RHC-3692 36in - 52.8lbs RHC-4892 48in - 62.7lbs Baffle Filter size: RHC-3092 30in - 14in x 14.7in x 0.6in RHC-3692 36in - 14in x 14.7in x 0.6in RHC-4892 48in - 14in x 14.7in x 0.6in...
Page 18
RHC-3092 30in SPECIFICATIONS: Body Design Seamless Stainless Steel, Satin Finish Power Rating 120V / 60Hz (USA & Canada standard) General Input Power 266 (260W + 2x3W) Motor Input Power 260 W (130W + 130W) Ampere Levels Of Speed Control 4 Levels...
Page 19
RHC-4892 48in SPECIFICATIONS: Body Design Seamless Stainless Steel, Satin Finish Power Rating 120V / 60Hz (USA & Canada standard) General Input Power 269 (260W + 3x3W) Motor Input Power 260 W (130W + 130W) Ampere Levels Of Speed Control 4 Levels Number Of Motors 2 Motors Motor Type...
Page 20
S W E D E N Your purchase comes with a 100% satisfaction guarantee from Janska If you are not happy with the product for any reason, please contact us at support@janskaus.com with your feedback or questions, and we will do our best to make...