SwiftSensors SG3-1010 Quick Start Manual page 6

Connect to Gateway
WiFi Hotspot
• From your phone, go to Settings > WiFi. Select Swift
1
Sensors (last four digits of your gateway ID). (It may
take a few minutes before the network appears).
• Scan the QR code on your gateway or below with your
2
phone, or open your phone's web browser and enter
192.168.42.1 to access your gateway's WiFi Setup.
• Tap the Set Up WiFi button. Select your WiFi Network
3
and tap the blue checkmark.
• Enter your WiFi network password and tap the blue
4
checkmark.
Gateway WiFI Setup
QR Code
Gateway Status Lights
• The gateway is booting up. This light is briefly visible right
after powering up the gateway.
The gateway is online and communicating with the Swift
•
Sensors Cloud.
• Blinking: the gateway is attempting to connect.
Solid: there is no internet at your facility.
The gateway is offline. If using WiFi, it could not connect
•
to your WiFi router. Try again with a different password.
• Blinking: the gateway is activating Set Up WiFi mode.
Solid: the gateway is in Set Up WiFi mode.
06 | Swift Sensors Quick Start Guide