LEAB MelfBox Quick Start Manual

Electrical supply system
for verhicles
MelfBox
Quick start guide
V 2
General Safety
This guide supports safe handling of the product. Use the product
only in accordance with its intended use:
The MelfBox is a vehicle electrical supply system. Assembly and in-
stallation should only be carried out by qualified electricians. Any
modifications to the product or its components are prohibited and
do not conform to its intended use. Only use original LEAB or
LEAB-approved accessories.
Observe the safety instructions:
DANGER! Danger from short circuits: Before operating, make
sure there are no open or damaged cables.
defective parts or damaged cables immediately.
NOTE! Reverse polarity can damage the unit: Before operating,
make sure that all cables are connected correctly.
NOTE! Equipment damage and danger of cable fire: Only use the
device within the specified voltage limits.
Technical Specifications
Part no. 1105002002
Modell MelfBox
Nominal voltage (AC) 230 V (+/- 10%)
Current, max. (AC) 16 A
Frequency 50 Hz
International Protection IP55
(IP class)
Protection class I
Operating display LED
Switch contact 1 A
Material Polyamide, glass fibre reinforced (PA6
GF30)
Cable cross-section 2.5 mm²
Contacts L1/N/PE
Installation depth 56 mm
Installation diameter 55 mm
Weight 0.12 kg
Dimensions (L x W x H) 62 mm x 67 mm x 67 mm
It is prohibited to copy, duplicate, translate or otherwise
pass on the content of this guide to third parties without the
express written permission of LEAB.
Package Contents
Accessories
DANGER! Replace
Creating a Body Cutout
To create the body cutout, proceed as follows:
1. Saw a hole (Ø 55 mm) in the vehicle body.
2. To prevent corrosion, seal the cut surfaces.
We make energy mobile.
LEAB Automotive GmbH
Thorshammer 6
DE-24866 Busdorf
Tel: +49 (0) 4621 9 78 60-0
Fax: +49 (0) 4621 9 78 60-260
info@leab.eu
No. Item
1x Cover
1x Housing
1x Housing seal
1x Body seal
3x Screw 3.5 x 14
1x Cap
Part number
1105001001
1105001002
1105001003
Fig. 1: MelfBox dimensions
ü Choose a vertical surface.
ü Choose an assembly site with minimum dust and which is pro-
tected from water.
ü Make sure that there is sufficient space at the assembly site.
ð The body cutout is now created.
Description
Connection cable 2.5 m
Connection cable 5 m
Connection cable 10 m