Clam Corp Fish Trap Guide 8060 Instruction Manual

Clam corporation fish trap guide bp2 instruction manual

Table of Contents

Download this manual

M o d e l N o .

- 8 0 6 0 -

p / n 1 0 8 3 0 6

S p e c i f i c a t i o n s

Height:

60" (21" packed)

W idth:

35 inches

Depth:

81" (35" packed)

W eight: 45 lbs.

NOT ICE!! Once used, this shelter cannot be returned to the store. If you ha ve a

Warrant y Clai m, please contact Clam Corporation Custome r Se rvice by emai l

inqui ry or di rect by calli ng:

Custo mer Service Hrs: - 8a m to 4p m, Mon. - Fri. Central Standard Time

Clam Corporation, Inc.

600 Clydesdale Trail

Medina, MN 55340

Phone - 763-231-4120

Fax - 763-231-4121

W ebsite – www.cla mcorp.co m

Email – www.custo merservice@clamco rp.co m

- C l a m C u s t o m e r S e r v i c e I n f o r m a t i o n -

C l a m C o r p o r a t i o n , I n c . M a n u a l – 1 0 2 1 7 8

Table of Contents

Need help?

Do you have a question about the Fish Trap Guide 8060 and is the answer not in the manual?

Page 1 M o d e l N o . - 8 0 6 0 - p / n 1 0 8 3 0 6 S p e c i f i c a t i o n s Height: 60” (21” packed) W idth: 35 inches Depth:...
Page 2 - S t e p O n e -...
Page 3 - S t e p T w o -...
Page 4 - S t e p T h r e e - Slide the Canopy Hoop Poles onto the Canopy Poles until the spring buttons engage the holes near the ends. Lean the Canopy Hoop Poles down and locate the Tent.
Page 5 - S t e p F o u r - Drape the Tent over the supported hoops then go inside and spread out the Canopy Hoop Poles, attaching the Roof Velcro as you go. Feed the length of the Porch Hoop Pole through the Porch Hoop Sleeve sewn on the Tent. Slide the Porch Hoop Pole onto the Porch Poles, engaging the second hole position.
Page 6 - S t e p F i v e - To “set” the tent, grasp the tent material at the rear of the shelter and pull it downward. Observe the porch area of the tent lifting accordingly as you pull. When the U-Channel Molding is correctly installed, the Porch Hoop Pole will lightly touch the floor.
Page 7 Folding and transporting your Fish Trap is easy: Push the spring buttons and retract each hoop, starting with the rear hoop and working towards the front. Rotate all retracted hoops to the resting position. Tuck the tent into the base and between the hoops so that no material is left hanging on the ground for transport.

8060Bass pro shops bp2