Turning Off The Projector - InFocus LP770 User Manual

S e t t i n g
NOTE: With some computers,
the order in which you power up
the equipment is very important.
Most computers should be turned
on last, after all other peripherals
have been turned on. Refer to your
computer's documentation to
determine the correct order.
NOTE: Do not turn the projector
off until the Lamp LED has
stopped blinking. This allows the
lamp to cool properly and extends
lamp life.
NOTE: If you accidentally use the
Main power switch to turn the
projector off while the lamp is on
or still cooling, allow the projector
to cool for 10 minutes before
attempting to turn it back on.
12
u p t h e
6 Turn on your computer.
The computer image should display on the projection
•
screen. If a video source is active, press the
ton on the remote or keypad to display your computer's
image. Make sure your laptop's external video port is acti-
vated; see "Portable and Laptop Activation Chart" on
page 42 for details.
Adjust the focus by pressing the
•
remote or keypad and using the
Zoom/Focus
for details.
If necessary, make adjustments to the image using the pro-
•
jector's on-screen menus. To open the menus, press the
button on the keypad or remote, then select the Pic-
Menu
ture or Option menus. For more information about the
menus, see page 20.

Turning Off the Projector

If you want to turn off the projector, press the
keypad or remote. A message appears, asking for verification.
Press again to turn the lamp off. (If you do not press
Power
again, the projector returns to normal operation.) The Lamp LED
blinks green for about 1 minute while the fans run and the lamp
cools. After a minute, the Lamp LED turns off and the projector is
in standby mode. This means you can either press the
ton to turn the lamp back on, or use the Main power switch to
turn the projector off.
You can set the projector to enter standby mode automatically
after no signal is detected for a certain amount of time; see "Auto
Power Off" on page 25 for details.
P r o j e c t
button again to zoom the image. See page 15
o r
Computer
button on the
Zoom/Focus
or buttons. Press the
+ -
button on the
Power
Power
but-
Power
but-