Advertisement
Model numbers: DSH-SRD2-P4-3; DSH-DRD2-P4-3; DSH-SRDP2-P4-3; DSH-DRDP2-P4-3
Quick Installation Guide - DJI Phantom 4 (all models)
1
Slide the alignment pin brackets on
both of the rear landing gear until
they lock in place
4
Press down the other side of the
Drone Sky Hook Arrow until it locks
to the landing gear
7
Slide the LED Sensor into the
narow section of the drone's arm
9
Fully insert the plug of the LED
Sensor cable into the 'SENS' port
on the Drone Sky Hook Arrow
DRONE SKY HOOK Ltd.
For Installation and Operation videos visit
Drone-Sky-Hook - ARROW
Professional Release & Drop device for DJI Phantom 4 / Phantom 3
2
Align the Drone Sky Hook Arrow's
hole with the aligment pin
5
The Alignment pins on both sides
shoud be fully inserted
8
The LED Sensor should fully cover the drone's lens
10
3
Press down the Drone Sky Hook
Arrow on one side until it locks to
6
The LED Sensors is installed under
the front right electric motor
Correct
Wrong
ALL SET !
www.droneskyhook.com/product-support
v1.2
the landing gear
www.droneskyhook.com
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Drone Sky Hook ARROW DSH-SRD2-P4-3
Summary of Contents for Drone Sky Hook ARROW DSH-SRD2-P4-3
- Page 1 Press down the other side of the The Alignment pins on both sides The LED Sensors is installed under Drone Sky Hook Arrow until it locks shoud be fully inserted the front right electric motor to the landing gear...
- Page 2 Align the Drone Sky Hook Arrow’s Press down the other side of the The locking pins should be fully hole with the alignment pin and Drone Sky Hook until it locks to the inserted press down on the Arrow until it landing gear...
Need help?
Do you have a question about the ARROW DSH-SRD2-P4-3 and is the answer not in the manual?
Questions and answers