Advertisement
Installation instructions – Slider window
Remove the window screen
This fan will extend beyond the window screen. Remove the window screen. The unit will be sealed in the installation
process. The unit also has a filter that will block insects and bugs so a screen is not necessary with this unit.
Install the bottom, and side weather strip
Place 2 glue squares on the bottom window side where EcoBreeze 2.2 will be placed. Cut the 52" weather strip to the
window width. Attach the weather strip to the bottom window sill. Place 4 glue squares on the frame side of the
window. Cut a piece from the 52" weather strip the height of the window and install the weather strip on the frame
side of the window.
Install the support bracket
Install the support bracket. Place it in the center of the window and snug it up until it is
approximately level. Remove from the window. Install one wide glue adhesive on the
vertical window sill face and the other on the vertical outside all face. Place the bracket
in the window and press it in place. Screws (user provided) may be used to secure the
bracket to the sill and outside wall.
Install the extender
Remove the upper screw from the window bracket. Loosen the center screw. Insert the extender
into the window bracket with the open slot on the top. Secure with the 2 end screws. Tighten the
middle screw.
Install the window side weather strip
Place 4 glue squares on the window where EcoBreeze 2.2 will be placed. Cut the 42" weather strip to the window
extender. With scissors cut the foam insulation panel approximately 1/8" larger for a snug fit. Slide foam in slot. Close
the window.
Install the center sash insulation
Cut the center sash insulation to the window height. Loop wire
tie around insulation for easy removal. Insert it in the gap
between the top window pane and the lower window frame with
the stiff insulation facing indoors. For some windows with a
narrow opening the insulation may be need to be smaller. Cut the insulation on
the softer insulation using scissors.
Enjoy Nature's summer cooling!
height. Attach the weather strip to the window.
Install EcoBreeze 2.2 in the window
Place EcoBreeze 2.2 on the windowsill. Close the window so the window frame is
between the window bracket and the motor dome. Slide the extender to the top
of the window frame and into the window channel. Add the 3" extenders as
required based on the height of the window.
Install the extender foam panel. Measure the opening in the adjustable
877-565-1457
5
Advertisement
