Advertisement
must use an extension cord, minimize the risk of overheating by using the shortest cord possible and ensuring it
is UL listed. NEVER use a single extension cord to operate more than one fan. DO NOT plug fan into any other
cord connected device such as a power strip, core reel, surge protector, multiple outlet adapters or outlet type
air fresheners. The use of such devices may create a fire hazard.
10. NEVER operate any fan with a damaged cord or plug or after the fan malfunctions, has been dropped or
damaged in any manner.
11. NEVER insert or allow fingers or foreign objects to enter any ventilation opening as it may cause electrical shock
or fire, or damage the fan. To reduce the risk of fire, DO NOT block or tamper with the fan in any manner while
it is in operation.
12. Locate the power cord so the fan or other objects are not resting on it. Do not run the cord under carpeting.
Do not cover the cord with throw rugs, runners, or similar coverings. Do not route the cord under furniture or
appliances. Arrange the cord away from traffic areas and where it will not be tripped over.
13. NEVER locate a fan where it may fall into a bathtub or other water container. NEVER use fan where flammable
liquids are stored.
14. DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void your
warranty. The inside of this contains no user serviceable parts. All servicing should be performed by qualified
personnel only.
15. This fan is not suitable for use in agricultural facilities including areas where livestock, poultry or other animals
are confined. Please refer to the National Electrical Code (NEC) Article 547-7 (2008), or applicable state or
16. local codes or standards relating to electrical requirements for Agricultural Buildings. THIS FAN DOES NOT
MEET THE REQUIREMENTS OF NEC ARTICLE 547-7 (2008).
17. This fan is not suitable for use in hazardous locations. Please refer to the National Electric Code (NEC) Article
500 or applicable state or local codes or standards relating to electrical requirements for Hazardous locations.
THIS FAN DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 500(2008).
Parts List
Insulating Weather strip
(1) 52" weather strip 1" x 0.5" for bottom and sides of unit
(1) 42" weather strip for top of unit
(1) 34" Center Sash 2 ply insulation
(1) Wire tie (6")
Double sided glue dots and support adhesive
Support Bracket
Side Extenders
Double hung window unit – 2 slider extenders and 2 insulated foam panels (7" x 9")
Vertical window unit – 1 slider extender, 1 insulated panel (7" x 9") and 3 insulated slot extenders
Tools Required
Scissors
Phillips head screw driver
877-565-1457
3
Advertisement
