CUSTERS HANDY Instruction Manual page 9

between 5th and 6th
step from bottom;
firmly screw wingnut
7
5
9
10/15
12/14/15
11
8
5: position the horizontal/diagonal
6: position the stairs; make sure the
stairs are properly secured (under the
rung)
7: position the stairs guardrail on the
inside of the stairs
8: place both horizontals on the stands of
the frames
9: apply the brakes and make the tower
level by rotating the wheels' spindle
nut
6
now assemble the four (large or small)
outriggers:
10: place the upper coupling below the 6
or 7
10
11: put base on the ground in compliance
with the prescribed base pattern
(see 4.4)
13
12: make sure the bottom coupling comes
between two rungs
13: turn the outrigger so that the
prescribed base pattern (see 4.4) is
achieved
14: loosely attach the bottom coupling to
the stand and push the coupling up
over the stand until the outrigger is a
little bit under pressure
15: firmly tighten both couplings
th
rung (small outrigger), 9
th
rung (large outrigger)
th
th
or
9