2-4 Camera ins tallation
Connect the Camera cable to the CCD. (Refer to Fig.6)
14.
15. Power on the CCU unit.
16. Rotate the CCD carefully by hand in order to set the camera target in parallel with the Marker on the
Camera Adjustment Jig (Slider). Then fix the Camera bracket-2 with the Allen screw tightly (Refer to
Fig.7)
(NOTE) In addition, please make sure " Position check line is displayed at the lower part on the monitor.
(Refer to Fig.8)
CCD
Fig.-6
Camera bracket-2
CCD
Fig.-7
Target
Marker
Position check line
Fig.-8
2 - 24
Camera cable
Allen screw
Position check line