Table of Contents
Advertisement
P V
M O D U L E
I N S T A L L A T I O N
M A N U A L
2.3 Instruction of Installation Methods
The Installation methods of DAH Solar
PV module are screw mounting and
clamp mounting.
Screws installing method
PV Module
Rated Power（W）
DHP60-(260-280)-5BB
260-280
Bolt
PV Module
Gaskets
Spring gaskets
Nut
1
PV Module
PV Module
2
3
Dimension(mm)
Installation hole pitch
1650*991*35*35
860; 1360; 941
Clamps mounting methods -
Using special clamps to install the modules
A
Notes:
1. All mentioned clamp mounting methods here are only for reference, DAH Solar will not be responsible for the system design
and installation. The mechanical loads and its safety must be operated and completed by the professional solar system installer
and experienced installation team.
2. Please ensure the following points before the clamps mounting:
a) Before the mounting, please check the safety performance of the junction box. Any body like insects or other things on the
surface of solar panels, please remove it.
b) Please check and ensure the PV modules serial number are correct.
3. DAH Solar PV module (only for the component model involved in this specification) (snow / wind load) product specification
load 3600 PPA load, back design load of 1600 PPA, safety factor 1.5 times. If modules installed in the snowy and strong windy
environment, the special protection actions should be taken to meet the installation requirements.
09
10
/
B
Advertisement
Table of Contents
