Advertisement
PACKAGE CONTENTS
Description
Part
Mirror Hanger
A
B
Lock Screw
Hanger Nail
C
Mirror with Backing
D
Crossbar
E
Mirror Frame
F
Steel Washer
G
!
WARNINGS AND CAUTIONS
CAUTION:
These instructions are provided for your safety. It is very important that they are read completely before
●
the installation of your fixture.
PREPARATION
Before beginning installation of product, make sure all parts are present. Compare parts with package
●
contents list and diagram above. If any part is missing or damaged, do not attempt to assemble, install or
operate the product. Contact customer service for replacement part.
Estimated Assembly Time : 15
●
Tools Required for Assembly (not included) : Flathead screwdriver Phillips screwdriver, pliers.
●
PREPARATION
:
STEP 1
*
Quoizel recommends 2 people for each step.
.
a
Place the Mirror Frame onto a flat working surface with the
back facing you. Carefully locate the Mirror with Backing
onto the Mirror Frame.
.
b
Locate Crossbars onto the Mirror Frame and match the
holes on them onto the Mounting Holes on the Mirror
Frame.
.
c
Pass Steel Washers over Lock Screws and then thread the
Lock Screws into the Mounting Holes on the Mirror Frame
and hand tighten until snug to secure them together.
INSTRUCTION SHEET IS JA43225
STYLE NUMBERS JA43225PN and JA43225BN
Quantity
2pcs
4pcs
4pcs
1pc
2pcs
1pc
4pcs
D
E
-
30 minutes
1 OF 3
-
:
ISSUED 09-2008
A
B
C
,
Mounting Hole
Mirror Frame
REVISED 2015-11-13
F
G
Crossbar
Mirror with
Backing
Lock Screw
Steel Washer
Advertisement
Table of Contents
Related Manuals for Quoizel JA43225PN
Summary of Contents for Quoizel JA43225PN
- Page 1 PREPARATION STEP 1 Crossbar Mounting Hole Mirror with Quoizel recommends 2 people for each step. Backing Place the Mirror Frame onto a flat working surface with the back facing you. Carefully locate the Mirror with Backing onto the Mirror Frame.
- Page 2 ASSEMBLY INSTRUCTIONS STYLE NUMBER JA43225PN, JA43225BN FOR VERTICAL STEP 2 Lift and position where the Mirror will reside on the wall surface and with a tape measure, mark distance from floor to the bottom edge of the frame with a pencil. Mark should be located at a point representing ½...
- Page 3 ASSEMBLY INSTRUCTIONS STYLE NUMBER JA43225PN, JA43225BN FOR HORIZONTAL STEP 6 Top Crossbar Lift and position where the Mirror will reside on the wall surface and with a tape measure, mark distance from floor 6” to the bottom edge of the frame with a pencil. Mark should be located at a point representing ½...
Need help?
Do you have a question about the JA43225PN and is the answer not in the manual?
Questions and answers