Advertisement
ASSEMBLY INSTRUCTIONS
FOR VERTICAL
:
STEP 2
.
a
Lift and position where the Mirror will reside on the wall
surface and with a tape measure, mark distance from floor
to the bottom edge of the frame with a pencil. Mark should
be located at a point representing ½ of mirror width.
b. Place the Mirror on a flat surface with back facing you.
Measure the distance from the bottom edge of the Mirror
Frame to the top edge of the Square Hole on Crossbar. This
represents distance "B" in the illustration.
c. With tape measure, add this distance to Mark "A" on wall
surface and mark with pencil.
d. Measure distance between 2 Square Holes on Crossbars.
Add this ½ distance from Mark "B" on each side and mark
with pencil. (Distance "C" in the illustration)
e. Measure 3" up from Mark "C" and mark. These marks are
locators for the (2)Mirror Hangers. Check for marks
straightness with level.
:
STEP 3
.
a Locate Mirror Hangers and align the top center with 3"
Locator mark. Secure them to wall surface with Hanger
Nails.
Please be noted that the Mirror Hangers are fully
adjustable allowing for easy leveling.
.
b With Mirror Hangers properly installed, be sure to make sure
that the (2)Bracket Catches are approximately equal in
length from the top of Mirror Hangers. Adjust overall length
with Adjustment Screws.
:
STEP 4
.
a With the help of another person, pass the holes on Crossbars over the Mirror Hangers so that the
Crossbars rests on the inside of the Bracket Catches.
.
c If needed, adjust mirror for straightness by eye or use level. Make corrections using Adjustment Screws on
Mirror Hangers.
:
STEP 5
.
a Clean glass with household glass cleaner. Retain this sheet for future reference.
Hanger Nail
2 OF 3
:
STYLE NUMBER JA43225PN, JA43225BN
"C"
"A"
½ WIDTH
Crossbar
Mark "B"
"
C
Bracket Catch
Square Hole
Crossbar
Floor
Surface
Mirror Hanger
Adjustment
Screw
Advertisement
