Fs P N M - Citizen BD2-2220 Command Reference Manual

FS p n m

support model
[Function] Printing the download NV bit images
[Code]
<1C>H<70>H<n><m>
[Range] 1≦n≦255、 0≦m≦3、48≦m≦51
[Outline] [The specification which is common to the model]
This command prints the download NV bit images (n) using a specified mode (m).
m
0,48
1,49
2,50
3,51
• "n" denotes the number of the download bit image.
• "m" denotes the bit image mode.
[Caution] • When the specified NV bit image "n" is undefined, this command is invalid.
• When the STANDARD MODE is selected, this command is valid only when there is no data in the
print buffer.
• This command is invalid when PAGE MODE is selected.
• Any printing modes except the upside-down printing mode (i.e. emphasis, double strike,
underlining, character size, inverted character printing, 90°-right-turned) are not affected.
• When the printing area set by the functions GS L and GS W is not enough for one vertical line of
the download NV bit image, the line alone is dealt with as follows.
One vertical line of the bit image is 1 dot in NORMAL MODE (m = 0, 48) and DOUBLE HEIGHT
MODE (m = 2, 50), and it is 2 dots in double WIDTH MODE (m = 1, 49) and QUADRUPLE SIZE
MODE (m = 3, 51).
(1) The printing area is extended to the right side within the limits of the printing area so that one
vertical line of the download NV bit image can be printed.
(2) When a sufficient printing area cannot be maintained even after executing (1), the printing
area is extended to the left side. (The left margin is reduced.)
• When the size of a bit image exceeds the limits of the printing area, the data within the limits of
the printing area will be printed but the parts exceeding the limit will not be printed.
• Regardless of the amount of line feed set with ESC 2 and ESC 3, NORMAL MODE and DOUBLE
WIDTH MODE execute a paper feed of (height "n" of NV bit image) dots while DOUBLE HEIGHT
MODE and QUADRUPLE SIZE MODE execute a paper feed of (height "n" of NV bit image x2) dots.
• At the completion of the bit image printing, the head of the line will be used for the next printing
position and normal data processing will take place.
[See Also] ESC *、FS q、GS /、GS v 0
CT-S280 CT-S300
PMU2XXX
Mode Name
NORMAL MODE
DOUBLE WIDTH MODE
DOUBLE HEIGHT MODE
QUADRUPLE SIZE MODE
CT-S2000 CT-S4000
Dot Density in
Vertical Direction
203dpi
203dpi
101dpi
101dpi
- 128 -
BD2-2220 CT-S310
Dot Density in
Horizontal Direction
203dpi
101dpi
203dpi
101dpi