Section 9: Zerodraw Mode (If Equipped) - ZeroRPM IMS2 Operator's Manual

IMS2, IMS3, IMS4, IMS5 Operator Manual
Section 9: ZeroDRAW™ Mode (If Equipped)
Any time the ignition switch is turned off after being in the
Run position, ZeroDRAW Mode will be engaged until one of
the following scenarios occurs:
• A predetermined amount of time has passed. This is
indicated by a countdown which appears on the Primary
Information Screen (see Section 12.1 for details).
• The ZeroDRAW SOC offset is reached. The default is 10%
over the SOC set point (e.g. low SOC = 20%; ZeroDRAW
Mode turns off at 30%).
• The operator has pressed the F2 soft key causing the
ZeroDraw feature to shutdown early to save energy. (F2
manual shut down is a custom feature available upon
request).
After either of the aforementioned scenarios occurs, the
IMS will switch back to the chassis lead-acid batteries and
disconnect non-OE loads to prevent parasitic draw on the
lead-acid batteries.
4806-00017
23
Revision F