Hibernation Mode - IBM ThinkPad A22e Hardware Maintenance Manual

Note: The computer does not accept any input
immediately after it enters standby mode. Wait a
few seconds before taking any action to reenter
operation mode.

Hibernation mode

Note for Windows NT
If you are using Windows NT in the default format,
NTFS, you cannot create a hibernation file. If you
want to use hibernation mode, you will need to
reinstall Windows NT with FAT format.
In hibernation mode, the following occurs:
v The system status, RAM, VRAM, and setup data are
stored on the hard disk.
v The system is powered off.
Note for the APM operating system
If you are running the computer on ac power and using a
communication PC Card, the computer cannot enter
hibernation mode.
To cause the computer to enter hibernation mode, do any
of the following:
v Press the Fn + F12 keys.
v If you are using the APM operating system and have set
the mode to Power switch mode [Hibernation], turn
off the power switch.
Also, the computer automatically goes into hibernation
mode in either of the following conditions:
v If you are using an operating system other than
Windows 98 and the timer conditions are satisfied in
suspend mode.
v If you are using the APM operating system and have set
the mode to Hibernate when battery becomes low,
and the battery charge becomes critically low.
Note: If you are using the ACPI operating system, you can
define closing the lid, pressing the Power button
and pressing Fn + F4 as events that cause the
system to go into hibernation mode.
When the power is turned on, the computer returns from
hibernation mode and resumes operation. The hibernation
file in the boot record on the hard-disk drive is read, and
system status is restored from the hard-disk drive.
30
ThinkPad A21e, A22e, i 1800 (MT 2655/2663/2664)
Related service information