Fisher & Paykel ACTIVESMART RF170B Installation Manual/User Manual page 47

All models
PROBLEM
Unfamiliar
noises.
Water in the
vegetable bins.
Exterior of
cabinet is warm.
Warm spot on
central door
seal. (French
door models
only).
Condensation
on outside of
refrigerator/
freezer.
Condensation
inside fresh food
compartment.
Door handles
out of
alignment.
Tray/bin does
not slide in and
out evenly.
Appliance
operating
inefficiently.
TROUBLESHOOTING
POSSIBLE CAUSES
Cabinet not stable or level.
Freezer is defrosting.
Condensation is formed by
the water produced by fruit
and vegetables.
This is normal.
You may feel a warm spot
at times on the central seal
between the two refrigerator
doors.
Not unusual during periods of
high humidity.
Frequent or long door
openings.
Door gasket leaking.
Not unusual during periods of
high humidity.
With time and usage,
movement may occur.
Packaging trapped.
Runners not extending fully.
Accumulation of dust on or
behind the rear compartment
cover.
WHAT TO DO
Refer to sections 'Installation
instructions' or 'ActiveSmart™ user
warnings and sounds' .
A small amount of condensation is
beneficial for fruit and vegetable
storage.
Wipe out water with a cloth.
Set humidity slide to
low humidity setting
This is perfectly normal and is part
of the normal refrigerator operation.
Wipe dry.
Minimize door openings.
Check that gasket is sitting flat and
sealing tightly.
Wipe dry.
Refer to section 'Installation
instructions'.
Check to ensure no food or
packaging is trapped behind the
tray/bin.
Holding onto sides of tray/bin,
extend the runners fully by using a
firm pull — this will reset the runner.
Refer to section 'Cleaning and caring
for your refrigerator'.
If problem persists please contact
Customer Care.
45