Fisher & Paykel CDV2 Series User Manual page 16

WHAT?
HOW?
HOW OFTEN?
1 Check that the burner is turned OFF
Simmer ring
2 Lift off the burner cap and brass
As needed,
disassemble
only if ports 3 Remove the hex nut at the top of
remain
clogged
4 Wash in hot soapy water using a
after normal
cleaning of
burner parts
5 Replace the simmer ring on burner
1 To remove stubborn stains, soak
Wok ring
(not supplied,
purchased
2 Wash in a mixture of hot water and
separately)
As needed,
but at least
once a month
CARE AND CLEANING
and allow it to cool.
flame spreader.
the simmer ring and lift off.
soft wire or plastic bristle brush,
rinse, and dry. Make sure all holes
are clear and open.
base and secure with the hex nut,
then replace the flame spreader
and burner cap. See 'Replacing the
burner parts'.
the wok ring in a mixture of clothes
washing detergent and water.
dishwashing liquid, then rinse and
allow to dry.
IMPORTANT!
Normal cleaning does
●
not require the simmer
ring to be disassembled,
however if ports remain
clogged after normal
cleaning it may be
necessary to remove the
simmer ring and clean
separately.
When replacing the
●
simmer ring, ensure
the locating pin on the
bottom aligns with the
corresponding hole
in the burner base.
Incorrect alignment will
produce a potentially
dangerous flame
and poor burner
performance.
Before replacing the
●
burner parts, check that
they are dry. Wet burner
parts may result in an
irregular flame.
Before lighting a burner
●
you have reassembled,
check that all of its parts
are positioned correctly.
Incorrect assembly
can cause dangerous
irregular flames and
ignition problems.
When replacing, place
●
the wok ring over the
grates, making sure the
small protrusions on
its bottom straddle the
grate fingers. The wok
ring should be stable
and unable to rotate.
15